Clamps - pneumatic

Pneumatic clamps are a fast and practical variant for the connection of leads. The lead is simply inserted into the guiding hole (several mm) until it touches the bottom of the hole. This activates a tensioning process, which fastens the lead in the clamp. If several clamps are used, the clamps are opened either individually or all at the same time after the test. This is extremely fast and efficient.

Product Overview

Product	Description	Technical Data	Article Number
	pneumatic clamp with 4mm hole	hole diameter 4mm	4000210
	pneumatic clamp with 6mm hole	hole diameter 6mm	4000500
	pneumatic clamp with 9mm hole	hole diameter 9mm	4000501
	Pneumatic clamps mounted side-by-side in a contacting unit. Each clamp can be opened individually or all clamps can be opened at the same time via a central release button.	hole diameter 3, 6, 10mm	configuration on request

The contacting takes place in 2-wire configuration. Therefore, ohmic resistances below 0.5W up to 1W can not be measured reliably any more. In case of small resistances, please use the 4-wire configuration with kelvin clamps kelvin tongs.

Kelvin Clamps Kelvin tongs / Kelvin clamps for an optimum contacting in 4-wire configuration. They can be used for measuring.... weiterlesen

Klemmenblock .... weiterlesen

Line Terminal Adapters Line terminal adapters allow a fast and reliable connection of line terminals for electronic products. .... weiterlesen

Sonderkontaktierungen .... weiterlesen